 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| TS432/432A/432B Adjustable Precision Shunt Regulator Sink Current Capability up to 100mA General Description The TS432/432A/432B is a three-terminal adjustable shunt regulator with specified thermal stability. The output voltage may be set to any value between Vref (approximately 1.24V) and 18V with two external resistors. The TS432/432A/432B has a typical output impedance of 0.2. Active output circuitry provides a very sharp turn-on characteristic, making the TS432/432A/432B excellent replacement for zener diode in many applications. This series is offered in 3-pin TO-92, SOT-89, SOT-23 and 5-pin SOT-25 package. Features Precision Reference Voltage TS432 1.24V2% TS432A 1.24V1% TS432B 1.24V0.5% Minimum Cathode Current for regulation: 150uA(typ) Equivalent Full Range Temp. Coefficient: 50ppm/ C Programmable Output Voltage up to 18V Fast Turn-On Response Sink Current Capability of 1.0 to 100 mA Low Dynamic Output Impedance: 0.2 Low Output Noise o Standard Application Ordering Information Part No. TS432xCT TS432xCY TS432xCX TS432xCX5 Note: Where x denotes voltage tolerance. Blank: 2% A: 1% B: 0.5% -20 ~ +85 C o Block Diagram Operating Temp. (Ambient) Package TO-92 SOT-89 SOT-23 SOT-25 Pin Assignment Pin No. TS432/A/BCT 1 2 3 Pin TS432/A/BCX5 4 5 3 1, 2 TS432/A/BCY 1 2 3 TS432/A/BCX 1 3 2 Description Reference Anode Cathode Non connect 2003/12 rev. A TS432/A/B 1-7 Absolute Maximum Rating Cathode Voltage (Note 1) Continuous Cathode Current Range Reference Input Current Range Power Dissipation (Note 2, 3) TO-92 TO-89 SOT-23 / SOT-25 Operating Junction Temperature Range Storage Temperature Range Note 2: Tj Max = 150 C Note 3: Rating apply to ambient temperature at 25 C o o Vka Ik Iref 20 -10 ~ 200 10 0.625 V mA mA Pd 0.5 0.3 W o o Tj TSTG 0 ~ +125 -65 ~ +150 C C Note 1: Voltage values are with respect to the anode terminal unless otherwise noted. Recommend Operating Condition Cathode Voltage Range Cathode Current Range (for regulation) Vka Ik Ref ~ 18 1 ~ 100 V mA Electrical Characteristics (Ta=25 C, unless otherwise specified.) Parameter Reference voltage TS432 TS432A TS432B Deviation of reference input voltage, over temp. (Note 4) Reference Input current Radio of change in Vref to change in cathode Voltage Deviation of reference input current, over temp. Minimum operating cathode current Off-state Cathode Current Dynamic Output Impedance Vref Ta = full range Vka =Vref, Ik=10mA (Figure 1) R1=10K, R2= , Ika=10mA (Figure 2) Ika=10mA, Vka = 18V to Vref (Figure 2) Ta= full range Iref(DEV) R1=10K, R2= , Ika=10mA (Figure 2) Ika(min) Ioff |Zka| Vka=Vref (Figure 1) Vref=0V (Figure 3) f<1KHz, Vka=Vref Ika=100uA to 15mA (Figure 1) Vka=18V ---60 0.5 0.2 200 2.0 0.5 uA uA -0.1 4.0 uA Vref Vka =Vref, Ik=10mA (Figure 1) Symbo Test Conditions Min 1.215 1.227 1.233 -5 1.240 Typ Max 1.264 1.252 1.246 20 mV V Unit o Iref Vref / Vka -- 0.15 4.0 uA -- -1.0 -2.7 mV/V TS432/A/B 2-7 2003/12 rev. A Note 4. Deviation of reference input voltage, VDEV, is defined as the maximum deviation of the reference over the full temperature range. The average temperature coefficient of the reference input voltage Vref is defined as: | Vref | = [ VDEV / Vref(25) ] * 106 / T2 - T1.......................... (PPM/ oC) Where: T2-T1 = full temperature change. Vref can be positive or negative depending on whether the slope is positive or negative. Note 5. The dynamic output impedance, Rz, is defined as: | Zka | = Vka / Ika When the device is programmed with two external resistors R1and R2 (see Figure 2). The dynamic output impedance of the overall circuit, is defined as : | Zka | = v / i | Zka | * ( 1 + R1 / R2) Test Circuits TS432/A/B 3-7 2003/12 rev. A Application Examples TS432/A/B 4-7 2003/12 rev. A Typical Performance Characteristics TS432/A/B 5-7 2003/12 rev. A TO-92 Mechanical Drawing A DIM TO-92 DIMENSION MILLIMETERS INCHES MIN 4.30 4.30 0.43 2.19 3.30 2.42 0.37 MAX 4.70 4.70 0.49 2.81 3.70 2.66 0.43 MIN 0.169 0.169 0.017 0.086 0.130 0.095 0.015 MAX 0.185 0.185 0.019 0.111 0.146 0.105 0.017 B A B C D E F G H 14.30(typ) 0.563(typ) C E F H D G SOT-89 Mechanical Drawing A B SOT-89 DIMENSION I DIM A B C MILLIMETERS MIN MAX 4.40 1.50 2.30 0.40 1.50 3.00 0.89 4.05 1.4 0.35 4.60 1.7 2.60 0.52 1.50 3.00 1.20 4.25 1.6 0.44 INCHES MIN MAX 0.173 0.059 0.090 0.016 0.059 0.118 0.035 0.159 0.055 0.014 0.181 0.070 0.102 0.020 0.059 0.118 0.047 0.167 0.068 0.017 H G C D E F G E D J H I J F TS432/A/B 6-7 2003/12 rev. A SOT-23 Mechanical Drawing A B F SOT-23 DIMENSION DIM A MILLIMETERS MIN MAX 2.88 0.39 1.78 0.51 1.59 1.04 0.07 2.91 0.42 2.03 0.61 1.66 1.08 0.09 INCHES MIN MAX 0.113 0.015 0.070 0.020 0.063 0.041 0.003 0.115 0.017 0.080 0.024 0.065 0.043 0.004 E B C D E F G G D C SOT-25 Mechanical Drawing SOT-23 DIMENSION DIM A B C D E F H L MILLIMETERS MIN 2.70 0.25 MAX 3.00 0.50 INCHES MIN 0.106 0.010 MAX 0.118 0.020 1.90(typ) 0.95(typ) 1.50 1.05 2.60 1.70 1.35 3.00 0.075(typ) 0.037(typ) 0.059 0.041 0.102 0.067 0.053 0.118 0.60(typ) 0.024(typ) TS432/A/B 7-7 2003/12 rev. A |
Price & Availability of TS432
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |